
Casambi LCM 10
The LCM ( lighting Controls Module) based on the Casambi Salvador 16 address module. It can control up to 15 sub address DALI luminaires. It has 10 ports, with each port having a permanent live, an emergency live, which can be switched off for testing, DALI+ and DALI-,Neutral, and Earth.
The emergency test relay can be activated via a hard wired emergency test input for use with a fish key, or over the Casambi network where it will appear on the app as a relay.
The enclosure has been designed for ease of installation with ‘Z’ bolt fixing rails on the rear. All the connections to the unit can also be pre-wired before installation.
-
10 x 6 pole sockets to connects luminaires
-
2 pole input for emergency testing
-
The LCM is not powered from the bus and requires a permanent mains supply from the relevant lighting circuit
-
Maximum Range Line of sight of 200m and 50m max if obstructed
-
Requires 6 pole plugs for luminaire wiring
-
Inputs 1 Emergency
-
DALI output 15 DALI addresses
-
Radio transceiver
-
Operating Frequencies 2402…2480 MHz
-
Maximum Power Output +8 dBm
-
Luminaire connection 6 way , Live , Earth, Neutral, Emergency Live, DALI-, DALI +
-
Degree of Protection IP20 ( indoor use only)
-
Supply voltage 90-240 V AC 50Hz
-
Power consumption Off load – 1.2 watts
-
All channels on – 4 watts
-
Internal fuse 1AT
-
Load (total) 10A
-
Load per channel 6A
-
Case material Flame Retardant ABS
-
Operating temperature -10 to +50°C
-
Max Humidity 90% RH non-condensing
Similar products
Control interfaces
CDBC
The CDBC is a compact Casambi-to-DALI controller with an integrated DALI bus power supply. Configurable via the Casambi App, it enables wireless dimming and colour control of compatible DALI luminaires.
Xiamen AcTEC Electronics Co.
Control interfaces
MC117S B1 N
Bluetooth Controllable Controller, 220-240Vac input, 10A Relay
Shenzhen Merrytek Technology Co.
Control interfaces
IC-A528-B-DA/0-10V-CW-CS
Circular smart controller for wireless control of lighting fixtures, which can adapt to LED drivers with D4i, DALI, 0-10V protocols by changing the profile and wiring method.
CUPOWER
Control interfaces
NAPPK DALI-0-10V-PWM-2CH-CAS
CUPOWER